Reply To: Hornby A2/2 conversion

Members Forum RTR Conversions Locos Hornby A2/2 conversion Reply To: Hornby A2/2 conversion

#242886
Bob Juleff
Participant

    Nigel,

    Glad to hear your B1 conversion has been successful.  I am guessing your axles were the normal 3mm diameter.  As for my project, I’m currently stalled.  The idea of using the 1/8″ to 2mm sleeves was a non starter as the 2mm hole is a sloppy fit on a 2mm axle.  Not surprising really as it’s designed for a freely running axle rather than a push fit.  A buddy with a lathe has kindly offered to make some sleeves to fit.

    Bob